Question: How do I change the password on my First Alert Safe?

With the safe in the open position, press the small reset button located on the inside top edge of the door. Enter your new three to eight digit (3-8) passcode followed by the # key. Immediately repeat the sequence, beginning with the new passcode followed by the # key.

How do I change my safe lock password?

A: Open the locker. Press ‘0’ button twice, followed by ‘*’ to enter in configuring mode. The buzzer will beep three times confirming that the locker is in ‘configuring the user code’ mode. You can now change your user code by entering your new 3 to 6 digit code followed by the ‘#’ key.

How do you change the combination on a First Alert safe?

Turn dial RIGHT, passing first combination number FOUR (4) times and stop and number on fifth time around. Turn dial LEFT, passing second combination number TWO (2) times and stop at number on third time around. Turn dial RIGHT, passing third combination number ONE (1) time and stop at number on the second time around.

How do you get into a First Alert safe without the combination?

Opening a Safe Without the Combination

First you must find the safe’s emergency key.

Remove the panel that covers your safe’s dial.

Once you have removed the dial panel, take a look beneath the dial itself.

Insert the emergency key into the emergency keyhole and turn it until the safe opens.

How do I reset my Mesa safe code?

Enter factory default code: (the “OPEN” LED lights up for 5 seconds ) 2. Turn handle clockwise, while the “OPEN” LED is GREEN. CHANGING THE USER CODE. AFTER CHANGING THE USER CODE PLEASE TEST THE NEW CODE 3 TO 5 TIMES WITH THE DOOR OPEN.

How do you open a 4 combination safe?

TO UNLOCK ON A TRUE FOUR NUMBER COMBINATION Starting anywhere, turn the dial right (clockwise), stopping when the first combination number comes to the opening index the FIFTH time. 2. Turn the dial left (counterclockwise), stopping when the second number comes to the opening index the FOURTH time.

How do I reset my First Alert safe 2060f?

Press and hold the reset button on the inside edge of the door closest to the hinges. When the safe is ready to be programmed, you will hear a beep and a light will flash on the keypad. Enter your new three to eight (3-8) digit passcode followed by ‘A’ or ‘B’. The light will once again flash and you will hear a beep.

How do I get my first alert to stop beeping?

Unmount and reset power If the unit is still chirping after you confirm that the device is mounted properly, unmount the unit. Then use your circuit breaker to turn off AC power, and then wait at least 15 seconds before turning power back on. Now remount the device.

How do I change the code on my intelligent electronic safe?

Open the safe, input “0” twice and press reset button, start setting code when the yellow light goes on. Input the new master code (3-8 digits), then press “C“ or “E” button to confirm, it will be confirmed by 1 buzzer beep and the yellow light will turn off, which indicates the acceptance and storage of the new code.

How do you open a locked safe?

Rotate the screwdriver in a counter-clockwise movement until the lock of the safe opens. Opening the safe with a knife perhaps is the easiest way. To achieve this, simply make use of the tip of the knife and insert it into the keyhole. Shake the knife a little and the lock will eventually open.

ncG1vNJzZmismJq2r7LIp6CtnZuewaS0xKdlnKedZLS2tcOeZqqtlajBqrvNZp%2Bor12ZvG61jJyfmqaXmnq1tMRmp5qro6y8s7CMqKVmpalis6q%2B0q1kmqSVp8Fuv8CfnGg%3D